Hitec Aggressor SRX Bedienungsanleitung PDF herunterladen (Seite 14)

C) EPA (End Point Adjustment)

- After entering the Programming mode press the "FUNC" button to scroll to the EPA menu.

- The current settings will show on this menu.

- STEERING EPA

- "Steering" will appear first. Use the "DATA" + button to adjust the EPA setting higher or the - button to

adjust it lower. The factory setting is 100%. You can increase the end points up to 125% or down to 0%.

- Note: You have to adjust left and right separately; you must move the wheel in the

direction you wish to set.

- Tip: Always max out the dual rate dial to 125% before setting your

individual end points for maximum travel.

- Tip: The best way to set the EPA is to turn and hold the steering wheel to

the left end, then increase or decrease the EPA so the servo moves the car's wheels or

the boat's rudder to their maximum travel without binding. Repeat for the right side.

- THROTTLE EPA

- Press the "SEL" button to get to the throttle EPA.

- To adjust the high throttle setting, pull and hold the trigger back.

To adjust the Brake EPA push and hold the trigger forward.

- Note: The ATL switch on the handle under the D/R dial will make the

same adjustment as the Brake EPA.

- Tip: The ATL can be adjusted on the fly for fine tuning the braking power of the vehicle,

and the current setting is displayed on the operating screen.

- AUXILIARY EPA "SHIFT"

- Press the "SEL" button to get to the "AUX" Auxiliary 3rd Channel EPA.

- If "SHIFT" was selected for this model, you will need to push the shift button to set each side of the travel.

- AUXILIARY EPA "LINEAR"

- Press the "SEL" button to get to the Auxiliary 3rd Channel EPA.

- Note: If "LINEAR" was selected for this model, you will need to move the AUX digital trim tab

on the right side of the steering column to the side you wish to set. Leaving the trim centered

will adjust both sides at once.

- Press the "SEL" button to loop back to the main EPA menu.

- Note: The main EPA menu will now show all the new settings.

- Note: Push the "DATA"+&-buttons at the same time to reset to factory default.

- Press the "FUNC" button to scroll to the next menu, or press the "FUNC" button for

three seconds to return to the operation screen.

EPA

AUX

EPA

1 2 ... 9 10 11 12 13 14 15 16

Keine Kommentare

Hitec Aggressor SRX Bedienungsanleitung Seite 14