Hitec ENERGY SPORT ESC SERIES Bedienungsanleitung

PROGRAMMABLE BRUSHLESS ESC

ACCELERATION: Soft, Normal and Hard [CONT.]3. Wait 2 seconds. You will hear 4 groups of two fast beeps. Aer this, groups of 4 varying beeps, tone

HELI GOVERNOR MODE: Off/Mode 1/Mode 2 [CONT.]6. When you hear _***_ _***_ _***_ _***_, you are now in the Heli Mode 1 program setting. If this

SWITCHING FREqUENCy: 8kHz and 16kHz1. Turn on your radio and set the throttle stick to the top, full “ON” positon (100%).2. Plug the battery pack

LOW VOLTAGE CUTOFF TyPE: [CONT.}5. When you hear ˉ _ ˉ _ ˉ _ ˉ_, you are at the Low Voltage Cuto Type – Hard Cut-o setting. If this is the setti

Programmable Items / SoundsAfter plugging in your ESC to your battery pack, within four seconds you will here 4 groups of two fast beeps. After this,

TWO yEAR LIMITED WARRANTyFor a period of two years from the date of purchase, HITEC RCD USA, INC. shall REPAIR OR REPLACE, at our option, defective eq

LIABILITy EXCLUSIONis electronic speed control is designed and approved exclusively for use with the types of batteries and motors stated in this Ins

INTRODUCTIONCongratulations on purchasing your new Hitec ENERGY electronic brushless motor speed control! Pre-wired with standard motor and battery co

SAFETy FEATURES [CONT.] If this occurs, we recommend you promptly land your plane and determine the cause of the overheating. Lost Signal Protection:

BEC OPERATIONe Energy Sport ESCs feature an onboard BEC circuit that provides power for the receiver and servos. Depending on the model, the BEC is c

USING THE ESC [CONT.]3. e motor will emit two sets of audible tones in succession. is tells you that the ESC is armed and ready to use. e rst set

ENTERING THE PROGRAMMING MODE [CONT.]2. Plug the battery pack into your controller.3. Wait 2 seconds. You will hear 4 groups of two fast beeps. Aer

BATTERy TyPE: NiCd/NiMH/LiPo [CONT.]3. Wait 2 seconds. You will hear 4 groups of two fast beeps. Aer this, 4 varying beeps, tones and melodies wi

SETUP DEFAULTS: Restore Factory Defaults1. Turn on your radio and set the throttle stick to the top, full “ON” positon (100%).2. Plug the battery

TIMING SETUP: (Auto, Low: 7-22° and High: 22-30°)1. Turn on your radio and set the throttle stick to the top, full “ON” positon (100%).2. Plug the